2-3
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 2 Installing the Access Point
Unpacking the Access Point
Warning
The access point, antennas, and all interconnected equipment including the associated LAN
connections must be located indoors within the same building.
Statement 375
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Unpacking the Access Point
Follow these steps to unpack the access point:
Step 1 Open the shipping container and carefully remove the contents.
Step 2 Return all packing materials to the shipping container and save it.
Step 3 Ensure that all items listed in the “Package Contents” section are included in the shipment. Check each
item for damage. If any item is damaged or missing, notify your authorized Cisco sales representative.
Package Contents
Each access point package contains the following items:
• Cisco Aironet 1250 series access point
• Mounting hardware kit
–
One mounting plate, two 4 x 40 x 3/16 in screws, and a mounting plate latch (all attached to the
access point)
–
Two suspended ceiling T-rail clips, spacers (accommodates standard and recessed T-rails), and
nuts.
–
Four 8 x 18 x 3/4 in pan head Phillips sheet metal screws
–
Four #8 plastic wall anchors
–
One 10 x 24 nut (for ground stud on the mounting plate)
–
Two cable tie wraps
• Product quick start guide
• Product translated safety warning document
• Cisco product registration and Cisco documentation feedback cards
To Next Page
Loading...
