Cisco AIR-AP1252AG-A-K9 - Removing a Radio Module

2-32
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 2 Installing the Access Point
Removing a Radio Module
Removing a Radio Module
The access point has two modules latches (on the bottom of the access point) for securing or removing
modules from the unit.
Note To install or remove a radio module, the access point must be removed from the mounting plate.
To remove a module from the access point, follow these steps:
Step 1 Place the access point, so that the bottom of the unit is facing up as shown in Figure 2-24.
Figure 2-24 Access Point Module Latches
1 Slot 1 module latch 3 Console connector and MODE button
2 DC-IN and Ethernet connectors 4 Slot 0 module latch
ETHERNET
170127
1 42 3
CONSOLE48vDC MODE