2-18
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 2 Installing the Access Point
Mounting to a Network Cable Box
Step 3 Repeat Steps 1 and 2 to install the second box hanger on the right side of the mounting bracket. Refer to
Figure Figure 2-13.
Figure 2-13 Securing the Right Side Mounting Clip to the Mounting Bracket
Step 4
Perform Steps 3 through 16 in the “Installing Option One” section on page 2-13.
Mounting to a Network Cable Box
Follow these steps to mount the access point on a network cable box.
Step 1 Position the mounting plate over the network cable box and align the appropriate mounting holes (See
Figure 2-2) with the holes of your specific network box.
Step 2 Hold the mounting plate and insert two or 4 #6 or #8 pan head screws (to match network box
configuration) through the mounting plate and into the corresponding threaded holes of the network box.
Step 3 Pull the access point cables out of the network box until there is about 1 foot of exposed cables
protruding from the box.
Step 4 Attach the access point to the mounting plate (see the “Installing the Access Point to the Mounting Plate”
section on page 2-24).
To Next Page
Loading...
