Cisco ASR 900 Series User Manual

•
Static labels. For information about configuring static labels, see MPLS Static Labels.
Verifying Configuration of MPLS Forwarding
To verify that MPLS forwarding has been configured properly, issue the show mpls interfaces detail command,
which generates output similar to that shown below:
SUMMARY STEPS
1.
show mpls interfaces detail
DETAILED STEPS
show mpls interfaces detail
Example:
Device# show mpls interfaces detail
Interface GigabitEthernet1/0/0:
IP labeling enabled (ldp)
LSP Tunnel labeling not enabled
MPLS operational
MTU = 1500
Interface POS2/0/0:
IP labeling enabled (ldp)
LSP Tunnel labeling not enabled
MPLS not operational
MTU = 4470
Additional References
Related Documents
Document TitleRelated Topic
Cisco IOS Master Commands List, All Releases
Cisco IOS commands
Cisco IOS Multiprotocol Label Switching Command
Reference
MPLS commands
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
7
Multiprotocol Label Switching (MPLS) on Cisco Routers
Verifying Configuration of MPLS Forwarding

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English