Cisco ASR 900 Series

SUMMARY STEPS
1.
enable
2.
configure terminal
3.
pseudowire-class class-name
4.
encapsulation mpls
5.
control-word
6.
mpls label protocol [ldp | none]
7.
exit
8.
pseudowire-class class-name
9.
encapsulation mpls
10.
exit
11.
l2 vfi name point-to-point
12.
neighbor ip-address vc-id {encapsulation mpls | pw-class pw-class-name}
13.
neighbor ip-address vc-id {encapsulation mpls | pw-class pw-class-name}
14.
mpls label local-pseudowire-label remote-pseudowire-label
15.
mpls control-word
16.
local interface pseudowire-type
17.
Do one of the following:
•
tlv [type-name] type-value length [dec | hexstr | str] value
•
tlv template template-name
18.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Creates a pseudowire class and enters pseudowire class
configuration mode.
pseudowire-class class-name
Example:
Device(config)# pseudowire-class mpls-tp-class1
Step 3
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
38
MPLS Transport Profile
Configuring Static-to-Dynamic Multisegment Pseudowires for MPLS-TP