Cisco ASR 900 Series

PurposeCommand or Action
Issues a local manual switch condition on a working label
switched path (LSP). This can be configured only in working
LSP mode on a TP tunnel interface.
manual-switch
Example:
Device(config-if-working)# manual-switch
Step 13
Exits working LSP mode.exit
Example:
Device(config-if-working)# exit
Step 14
Exits TP interface tunnel mode.exit
Example:
Device(config-if)# exit
Step 15
Configuring Static-to-Static Multisegment Pseudowires for MPLS-TP
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
l2 vfi name point-to-point
4.
bridge-domainbridge-id
5.
neighbor ip-address vc-id {encapsulation mpls | pw-class pw-class-name}
6.
mpls label local-pseudowire-label remote-pseudowire-label
7.
mpls control-word
8.
neighbor ip-address vc-id {encapsulation mpls | pw-class pw-class-name}
9.
mpls label local-pseudowire-label remote-pseudowire-label
10.
mpls control-word
11.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
35
MPLS Transport Profile
Configuring Static-to-Static Multisegment Pseudowires for MPLS-TP