Cisco ASR 900 Series

Configuring the MPLS-TP Tunnel
On the endpoint devices, create an MPLS TP tunnel and configure its parameters. See the interface tunnel-tp
command for information on the parameters.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface tunnel-tp number
4.
description tunnel-description
5.
tp tunnel-name name
6.
tp source node-id [global-id num]
7.
tp destination node-id [tunnel-tp num[ global-id num]]
8.
bfd bfd-template
9.
working-lsp
10.
in-label num
11.
out-label num out-link num
12.
exit
13.
protect-lsp
14.
in-label num
15.
out-label num out-link num
16.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
27
MPLS Transport Profile
Configuring the MPLS-TP Tunnel