Cisco ASR 900 Series User Manual

PurposeCommand or Action
Example:
Device(config-vfi)# neighbor 10.111.111.111 123
pw-class atom
Note: Only two neighbor commands are
allowed for each l2 vfi point-to-point
command.
Note
Sets up an emulated VC.
neighbor ip-address vc-id {encapsulation mpls | pw-class
pw-class-name}
Step 13
Only two neighbor commands are allowed
for each l2 vfi point-to-point command.
Note
Example:
Device(config-vfi-neighbor)# neighbor
10.111.111.111 123 pw-class atom
Configures the static pseudowire connection by
defining local and remote circuit labels.
mpls label local-pseudowire-label remote-pseudowire-label
Example:
Device(config-vfi-neighbor)# mpls label 10000 25000
Step 14
Specifies the control word.mpls control-word
Example:
Device(config-vfi-neighbor)# mpls control-word
Step 15
Specifies the pseudowire type.
local interface pseudowire-type
Example:
Device(config-vfi-neighbor)# local interface 4
Step 16
Specifies the TLV parameters or invokes a previously
configured TLV template.
Do one of the following:
Step 17
•
tlv [type-name] type-value length [dec | hexstr | str]
value
•
tlv template template-name
Example:
Device(config-vfi-neighbor)# tlv statictemp 2 4
hexstr 1
Ends the session.end
Example:
Device(config-vfi-neighbor)# end
Step 18
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
40
MPLS Transport Profile
Configuring Static-to-Dynamic Multisegment Pseudowires for MPLS-TP

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English