Cisco ASR 900 Series

PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Creates a point-to-point Layer 2 virtual forwarding interface
(VFI) and enters VFI configuration mode.
l2 vfi name point-to-point
Example:
Device(config)# l2 vfi atom point-to-point
Step 3
Configures the bridge domain service instance.
bridge-domainbridge-id
Step 4
Example:
Device)config)# bridge-domain 400
• bridge-id—Bridge domain identifier. The valid values
are from 1 to 4000.
Sets up an emulated VC. Specify the IP address, the VC ID
of the remote device, and the pseudowire class to use for
the emulated VC.
neighbor ip-address vc-id {encapsulation mpls |
pw-class pw-class-name}
Example:
Device(config-vfi)# neighbor 10.111.111.111 123
pw-class atom
Step 5
Only two neighbor commands are allowed for
each Layer 2 VFI point-to-point command.
Note
Configures the static pseudowire connection by defining
local and remote circuit labels.
mpls label local-pseudowire-label
remote-pseudowire-label
Example:
Device(config-vfi)# mpls label 10000 25000
Step 6
Specifies the control word.mpls control-word
Example:
Device(config-vfi)# mpls control-word
Step 7
Sets up an emulated VC. Specify the IP address, the VC ID
of the remote device, and the pseudowire class to use for
the emulated VC.
neighbor ip-address vc-id {encapsulation mpls |
pw-class pw-class-name}
Example:
Device(config-vfi)# neighbor 10.10.10.11 123
pw-class atom
Step 8
Configures the static pseudowire connection by defining
local and remote circuit labels.
mpls label local-pseudowire-label
remote-pseudowire-label
Example:
Device(config-vfi)# mpls label 11000 11001
Step 9
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
36
MPLS Transport Profile
Configuring Static-to-Static Multisegment Pseudowires for MPLS-TP