Cisco ASR 900 Series

PurposeCommand or Action
Specifies the encapsulation type.encapsulation mpls
Example:
Device(config-pw-class)# encapsulation mpls
Step 4
Enables the use of the control word.control-word
Example:
Device(config-pw-class)# control-word
Step 5
Specifies the type of protocol.mpls label protocol [ldp | none]
Example:
Device(config-pw-class)# protocol none
Step 6
Exits pseudowire class configuration mode and returns
to global configuration mode.
exit
Example:
Device(config-pw-class)# exit
Step 7
Creates a pseudowire class and enters pseudowire class
configuration mode.
pseudowire-class class-name
Example:
Device(config)# pseudowire-class mpls-tp-class1
Step 8
Specifies the encapsulation type.encapsulation mpls
Example:
Device(config-pw-class)# encapsulation mpls
Step 9
Exits pseudowire class configuration mode and returns
to global configuration mode.
exit
Example:
Device(config-pw-class)# exit
Step 10
Creates a point-to-point Layer 2 virtual forwarding
interface (VFI) and enters VFI configuration mode.
l2 vfi name point-to-point
Example:
Device(config)# l2 vfi atom point-to-point
Step 11
Sets up an emulated VC and enters VFI neighbor
configuration mode.
neighbor ip-address vc-id {encapsulation mpls | pw-class
pw-class-name}
Step 12
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
39
MPLS Transport Profile
Configuring Static-to-Dynamic Multisegment Pseudowires for MPLS-TP