Cisco ASR 900 Series

Reverse Associated LSP Information:
Signaled Name: 4.4.4.4 1001
Tunnel: 1001, Source: 4.4.4.4, Dest: 1.1.1.1, LSP: 9 State: Up
Lockout Info:
Locked out: No
Lockout Originated By: None
Association:
Association Type: Double Sided Bidirectional LSPs
Association ID: 1001 Source: 1.1.1.1
Extended Association:
Global source: 1001
Extended ID: None
RSVP Signalling Info:
Src 1.1.1.1, Dst 4.4.4.4, Tun_Id 1001, Tun_Instance 9
RSVP Path Info:
My Address: 10.1.1.1
Explicit Route: 10.1.1.2 10.1.1.2* 22.1.1.1* 4.4.4.4*
Record Route:
Tspec: ave rate=200 kbits, burst=1000 bytes, peak rate=200 kbits
RSVP Resv Info:
Record Route: 22.1.1.2 22.1.1.1
Fspec: ave rate=200 kbits, burst=1000 bytes, peak rate=200 kbits
Shortest Unconstrained Path Info:
Path Weight: 2 (TE)
Explicit Route: 11.1.1.2 20.1.1.1 4.4.4.4
Reason for the tunnel being down: Bidirectional: standby error from [1.1.1.1][UNK] LSP[8]
History:
Tunnel:
Time since created: 7 minutes, 51 seconds
Number of LSP IDs (Tun_Instances) used: 9
Current LSP: [ID: 9]
Uptime: 5 minutes, 59 seconds
At PE2
Router# show mpls traffic-eng tunnels tunnel 1001
Name: PE2_t1001 (Tunnel1001) Destination: 1.1.1.1
Status:
Admin: up Oper: up Path: valid Signalling: connected
path option 1, type explicit (verbatim) ThruHunG (Basis for Setup, path weight 0)
Path Protection: Requested
path protect option 1, type explicit (verbatim) PROT1 (Basis for Protect, path weight
0)
Config Parameters:
Bandwidth: 200 kbps (Global) Priority: 7 7 Affinity: 0x0/0xFFFF
Metric Type: TE (default)
AutoRoute: disabled LockDown: disabled Loadshare: 200 [10000000] bw-based
auto-bw: disabled
Association Type: Double Sided Bidirectional LSPs, Co-routed: NO
Association ID: 1001, Source: 1.1.1.1, Global ID: 1001
Fault-OAM: disabled, Wrap-Protection: disabled, Wrap-Capable: No
Active Path Option Parameters:
State: explicit path option 1 is active
BandwidthOverride: disabled LockDown: disabled Verbatim: enabled
InLabel : -
OutLabel : BDI221, 980
Next Hop : 23.1.1.2
Reverse Associated LSP Information:
Signaled Name: 1.1.1.1 1001
Tunnel: 1001, Source: 1.1.1.1, Dest: 4.4.4.4, LSP: 9 State: Up
Lockout Info:
Locked out: No
Lockout Originated By: None
Association:
Association Type: Double Sided Bidirectional LSPs
Association ID: 1001 Source: 1.1.1.1
Extended Association:
Global source: 1001
Extended ID: None
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
149
Flex LSP Overview
Verifying the Non Co-routed Inter-area Flex LSP Tunnels