2-13
Cisco ASR 9000 Series Aggregation Services Router Overview and Reference Guide
OL-17501-09
Chapter 2 Functional Description
Route Processor Card
PDxy Loading programmable devices (x = FPGA, y = ROMMON).
PSTx Power on self test x.
RMN All tests finished and ROMMON is ready for commands.
LOAD Downloading Minimum Boot Image (MBI) image to CPU.
MBI Starting execution of MBI.
IOXR Cisco IOS XR Software is starting execution.
ACTV RSP role is determined to be active RSP.
STBY RSP role is determined to be standby RSP.
PREP Preparing disk boot.
Table 2-4 RSP-440 and RP LED Matrix Boot Stage and Runtime Display
LED Matrix Display Description
INIT Card is inserted and microcontroller is initialized.
BOOT Card is powered on and CPU is booting.
IMEM Starting initialization of memory.
IGEN Starting initialization of card.
ICBC Initializing communication with the microcontroller.
SCPI Board is not plugged in properly.
STID CBC was unable to read slot ID pins correctly.
PSEQ CBC detected power sequencer failure.
DBPO CBC detected an issue during board power up.
KPWR CBC detected an issue during board power up.
LGNP CBC detected an issue during board power up.
LGNI CBC detected an issue during board power up.
RMN All tests finished and ROMMON is ready for commands.
LOAD Downloading Minimum Boot Image (MBI) image to CPU.
RRST ROMMON rebooting board after MBI validation timeout.
MVB ROMMON trying MBI validation boot.
MBI Starting execution of MBI.
IOXR Cisco IOS XR Software is starting execution.
LDG The RSP/RP is loading (MBI started and card preparing for
activity).
INCP The software or configuration is incompatible with the
RSP/RP.
OOSM The RSP/RP is in Out of Service, Maintenance mode.
Table 2-3 RSP LED Matrix Boot Stage and Runtime Display (continued)
LED Matrix Display Description
To Next Page
Loading...
Need help?
General
