Figure 35: Attaching the Cables to the Switch
Pivot direction for cable
guard pivots
2Cables1
Step 5 Guide the connected cables through the slots in the front of the cable guard. Slide the cable guide in as shown in the
following figure. Tighten the screws.
Figure 36: Guiding the Cables through the Guard
Step 6 (Optional) To attach the cable guard to the desk or wall, use a 0.144-inch (3.7 mm) or a #27 drill bit to drill 1/2-inch (12.7
mm) holes at each of the two mounting locations. Insert the supplied 0.5 in. (12.7 mm) number-8 Phillips wood screws
and tighten them.
Cisco Catalyst 2960-L Series 8-Port and 16-Port Switch Hardware Installation Guide
37
Switch Installation
Installing the Cable Guard (Optional)
To Next Page
Loading...
