Power Injectors
The IW9167I Access Point supports the following power injectors:
• IW-PWRINJ-60RGDMG=: Operating: -40°C to +70°C. Power derating of 60W at 70°C, and 65W at
65°C. Supports 100M/1G/2.5G/5G/10G rates.
• AIR-PWRINJ-60RGD1=: Operation: -40°C to +50°C, 60W. Supports 10M/100M/1G rates.
• AIR-PWRINJ-60RGD2=: Operation: -40°C to +50°C, 60W. Supports 10M/100M/1G rates.
To reduce the risk of fire, use only No. 24 AWG or larger telecommunications line cord. Statement 1023
Warning
When the AP is installed outdoors or in a wet or damp location, the AC branch circuit powering the AP should
be provided with ground fault protection (GFCI), as required by Article 210 of the National Electrical Code
(NEC).
Caution
Ethernet (PoE) Ports
The AP supports an Ethernet uplink port (also for PoE-IN). The Ethernet uplink port on the AP uses an RJ-45
connector (with weatherproofing) to link the AP to the 100BASE-T, 1000BASE-T, 2.5G BASE-T, or 5G
BASE-T network. The Ethernet cable is used to send and receive Ethernet data and optionally supply inline
power from the power injector or a suitably powered switch port.
The AP senses the Ethernet and power signals, and automatically switch internal circuitry to match the cable
connections.
Tip
To reduce the risk of fire, use only No. 24 AWG or larger telecommunication line cord. Statement 1023
Danger
The Ethernet cable must be a shielded, outdoor rated, Category 5e (CAT 5e) or better cable. Category 6A
(CAT 6A) cable is needed for 5G rate. The AP senses the Ethernet and power signals and automatically
switches internal circuitry to match the cable connections.
SFP Option
Class 1 laser product. Statement 1008
Warning
The factory-orderable fiber option provides a fiber input and output capability. Fiber data is transmitted and
received over a single or dual-strand fiber cable, depending on the SFP, which is connected to the access point
using these SFP modules:
Cisco Catalyst IW9167I Heavy Duty Access Point Hardware Installation Guide
6
About Cisco Catalyst IW9167I Heavy Duty Access Point
Power Injectors
To Next Page
Loading...
Need help?
General
