CHAPTER 3
Installation Overview
• Performing a Preinstallation Configuration (Optional), on page 15
• Preinstallation Checks and Installation Guidelines, on page 17
• Mounting the Access Point, on page 18
• Attaching a Power Adapter, on page 30
• Grounding the Access Point, on page 33
• Powering the Access Point, on page 34
• Connecting Data Cables, on page 39
Performing a Preinstallation Configuration (Optional)
The following procedures describe the processes to ensure that your AP installation and initial operation go
as expected.
Performing a preinstallation configuration is an optional procedure. If your network controller is properly
configured, you can install your AP in its final location and connect it to the network from there.
Note
The following illustration shows the preinstallation configuration setup:
Cisco Catalyst IW9167I Heavy Duty Access Point Hardware Installation Guide
15
To Next Page
Loading...
