To Next PageTo Next Page
Need help?Do you have a question about the Cisco CGS 2520 and is the answer not in the manual?
General| Model | Cisco CGS 2520 |
|---|---|
| Power Device | Internal power supply |
| Height | 1.7 in |
| Stacking | No |
| MAC Address Table Size | 8192 entries |
| Routing Protocol | Static IP routing |
| Remote Management Protocol | SNMP, SSH, Telnet, HTTP/HTTPS |
| Features | VLAN support, QoS, Access Control List (ACL) support, IGMP snooping, Port mirroring |
| Compliant Standards | IEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z |
| Voltage Required | 100 to 240 VAC |
| Width | 17.5 in |
| Operating Humidity | 10% to 90% (non-condensing) |
| Power over Ethernet (PoE) | PoE+ |
Details the different Cisco CGS 2520 switch models and their configurations.
Provides critical safety warnings and environmental guidelines before installing the switch.
Step-by-step instructions for mounting the switch into various types of racks and onto walls.
Procedures for connecting devices to Ethernet ports and understanding cable requirements for network setup.
Information on the available power supply modules (AC/DC) and their specifications.
Provides guidelines and safety measures for installing or removing power supply modules.
Detailed steps for installing power supply modules and connecting them to the power source.
Uses switch LEDs, POST results, and connection checks to identify problems.
