EasyManuals Logo

Cisco CGS 2520 User Manual

Cisco CGS 2520
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
4-6
Cisco CGS 2520 Hardware Installation Guide
OL-31444-01
Chapter 4 Troubleshooting
Resetting the Switch to the Factory Default Settings
Resetting the Switch to the Factory Default Settings
Follow these steps to return your switch to the factory default settings.
Note Resetting the switch deletes the configuration and reboots the switch.
To reset the switch:
1. At the switch prompt, enter enable, and press Return or Enter.
2. At the Privileged EXEC prompt, switch#, enter setup and press Return or Enter.
The switch displays the prompt to run the initial configuration dialog. See the “Configuring the Switch
with the CLI Setup Program” section on page C-1
Finding the Switch Serial Number
If you contact Cisco Technical Assistance, you need to know the switch serial number. Figure 4-1 and
Figure 4-2 show the serial number locations. You can also use the show version privileged EXEC
command to see the switch serial number.
Figure 4-1 Serial Number Location for Cisco CGS-2520-24TC and CGS-2520-16S-8PC Switches
Figure 4-2 Serial Number Location for the Power Supply Modules
207769
SN: XXXNNNNXXXX
Cisco Connected Grid
Switch 2500 Series
SN: XXXNNNNXXXX
207452

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CGS 2520 and is the answer not in the manual?

Cisco CGS 2520 Specifications

General IconGeneral
BrandCisco
ModelCGS 2520
CategorySwitch
LanguageEnglish

Related product manuals