APPENDIX
Operating Conditions for the United Kingdom E-1
Operating Conditions for the United
Kingdom
E
For United Kingdom Use Only
Cisco Systems declaration of operating conditions:
The Cisco 4000 series router is designed to meet the requirements of NET1 and NET2.
Warnings
Interconnection directly, or by way of other apparatus, of ports marked:
“Safety Warning — See instructions for use”
with ports marked or not so marked may produce hazardous conditions on the network and that
advice should be obtained from a competent engineer before such a connection is made.
The ports marked “Ethernet,” “10BaseT,” “Token Ring,” “Console,” and “AUX” have a safety
warning applied to them as follows:
“These ports do not provide isolation sufficient to satisfy the requirement of BS6301; apparatus
connected to these ports should either have been approved to BS6301 or have previously been
evaluated against British Telecommunications plc (Post Office) Technical Guides 2 or 26 and given
permission to attach; any other usage will invalidate any approval given to this apparatus.”
Connection of Power Supply. The Gateway Server is intended for use when supplied with power
from a supply providing 220-240 VAC, 50/60 Hz up to 5 Amps.
Other usage will invalidate any approval given to this apparatus if as a result it ceases to comply with
BS6301: 1989.
The Cisco 4000 router is brou
ght into service by the supplier.
To Next Page
Loading...
Need help?
General
