To Next Page

To Previous Page

Installing the Router 3-15

Making Network Connections

Step 6 At the prompt, specify the channel-group modification command, channel-group and

timeslots to be mapped. The example shows channel-group 0 and timeslots 1, 3 through 5,

and 7 selected for mapping.

Router(config-controller)# channel-group 0 timeslots 1,3-5,7

Router(config-controller)#

%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1:0, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1:0, changed state to up

Router(config-controller)#

Step 7 At the prompt, specify the interface, serial, unit number, and channel-group to modify.

Router(config-controller)# int serial 1:0

Step 8 At the prompt, assign an IP address and subnet mask to the interface with the ip address

configuration subcommand as in the following example:

Router(config-if)# ip address 1.1.15.1 255.255.255.0

Router(config-if)#

Step 9 Add any additional configuration subcommands required to enable routing protocols and

adjust the interface characteristics.

Step 10 After including all of the configuration subcommands, to complete the configuration, enter

^Z (hold down the Control key while you press Z) to exit the configuration mode.

Step 11 Write the new configuration to memory as follows:

Router# write memory

The system will display an OK message when the configuration is stored.

Step 12 Exit the privileged level and return to the user level by entering disable at the prompt as

follows:

Router# disable

Router>

Step 13 Check the interface configuration with show commands.

Refer to the printed Router Products Configuration Guide and Router Products Command Reference

publications or UniverCD for a summary of the configuration options available and additional

instructions for configuring the CT1 module.

Cisco EF4116 User Manual

Questions and Answers: