Cisco MDS 9132T User Manual

CHAPTER 4
Installing the Cisco MDS 9132T Switch
This chapter describes how to install the Cisco MDS 9132T switch and its components.
Before you install, operate, or service the system, see the Regulatory Compliance and Safety Information
for the Cisco MDS 9000 Family for important safety information.
Note
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security. Statement
1017
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Each new switch requires a license; see the Cisco MDS 9000 Family NX-OS Licensing Guide for
instructions on installing a license.
Note
•
Preinstallation, page 21
•
Installing the Switch, page 27
•
Grounding the Switch, page 35
•
Installing and Removing Components, page 36
Preinstallation
This section includes the following information:
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
21

Cisco MDS 9132T Specifications

General

Brand	Cisco
Model	MDS 9132T
Category	Switch
Language	English