Cisco MDS 9132T User Manual

SpecificationDescription
Chassis requires 1 RU (1.75 in. or 4.45 cm)Rack Space
21.65 lb (9.82kg)Weight
•
650 W AC, Port-side exhaust variant (up to 2
per switch)
•
650 W AC, Port-side intake variant (up to 2 per
switch)
•
AC input: 100 to 240 V AC (10% range)
•
Frequency: 50 to 60 Hz (nominal)
Power Supply
•
Back to front (toward ports) using port side
exhaust fans
•
Front to back (into ports) using port side intake
fans
•
50 CFM (0.02 m
3
/s) through system fan
assembly at 25°C
•
100 CFM (0.04 m
3
/s) maximum
Cisco recommends that you maintain a minimum air
space of 2.5 in. (6.4 cm) between walls and chassis
air vents and a minimum horizontal separation of 6
in. (15.2 cm) between two chassis to prevent
overheating.
Airflow
Power Specifications
General Power Supply Specifications
The following table lists the specifications for the Cisco MDS 9132T switch AC input power supply.
SpecificationAC Input Power
100 to 240 VACAC input voltage
Nominal = 50 to 60 HzAC input frequency
650 WPower supply output capacity
12 V +/- 5% up to 54 APower supply output voltage
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
54
Technical Specifications
Power Specifications

Cisco MDS 9132T Specifications

General

Airflow	Front-to-back
Product Type	Fibre Channel Switch
Rack-mountable	Yes
Manageable	Yes
Product Model	MDS 9132T
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Power Supply	AC
Data Transfer Rate	32 Gbps
Fibre Channel Standard	FC-FS-2, FC-GS-4, FC-SW-2
Humidity	5% to 93% (non-condensing)
Ports	32 x 32Gbps Fibre Channel
Form Factor	1U
Dimensions	1.72 x 17.3 x 19.2 in
Port Speed	32 Gbps
Weight	17.6 lbs (8 kg)