Cisco MDS 9132T User Manual

StateStatus
The link is up (indicates traffic on the port).Intermittent flashing Green
The link is disabled by the software.Solid Orange
A faulty condition exists.Flashing Orange
No link.Off
Supported SFP+ Transceivers
SFP+ transceivers are field-replaceable. You can use any combination of SFP+ transceivers that are supported
by the switch. The only restrictions are that SWL transceivers must be paired with SWL transceivers on the
peer device, and LWL transceivers with LWL transceivers on the peer device, and the cable must not exceed
the stipulated cable length for reliable communications.
For the list of SFP+ transceivers supported on the Cisco MDS 9132T Switch, see the SFP Transceiver
Specifications section. SFP+ transceivers can be ordered separately or with the Cisco MDS 9132T Switch.
Use only Cisco SFP+ transceivers in the Cisco MDS 9132T switches. Each Cisco SFP+ transceiver is
encoded with model information that enables the switch to verify that the SFP+ transceiver meets the
requirements for the switch.
Note
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
16
Product Overview
Supported SFP+ Transceivers

Cisco MDS 9132T Specifications

General

Brand	Cisco
Model	MDS 9132T
Category	Switch
Language	English