Cisco MDS 9132T User Manual

APPENDIX A
Cable and Port Specifications
This appendix includes the cables and connectors used with the Cisco MDS 9132T Multilayer Fabric Switch.
We strongly recommend that power cable runs and other potential noise sources be located as far away
as practical from network cabling that terminates on Cisco equipment. In situations where long parallel
cable runs exist but cannot be separated by at least 3.3 ft. (1 m), we recommend that you shield these
potential noise sources. To avoid interference, the source should be shielded by housing it in a grounded
metallic conduit.
Caution
•
Cables and Adapters, page 65
•
Console Port, page 66
•
MGMT 10/100/1000 Ethernet Port, page 68
•
Supported Power Cords and Plugs, page 70
Cables and Adapters
The Cisco MDS 9132T Switch accessory kit includes the following:
•
RJ-45 to RJ-45 rollover cable
• RJ-45 to DB-9 female DTE adapter (labeled “Terminal”)
• RJ-45 to DB-25 female DTE adapter (labeled “Terminal”)
• RJ-45 to DB-25 male DCE adapter (labeled “Modem”)
Additional cables and adapters can be ordered from your customer service representative.Note
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
65

Cisco MDS 9132T Specifications

General

Airflow	Front-to-back
Product Type	Fibre Channel Switch
Rack-mountable	Yes
Manageable	Yes
Product Model	MDS 9132T
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Power Supply	AC
Data Transfer Rate	32 Gbps
Fibre Channel Standard	FC-FS-2, FC-GS-4, FC-SW-2
Humidity	5% to 93% (non-condensing)
Ports	32 x 32Gbps Fibre Channel
Form Factor	1U
Dimensions	1.72 x 17.3 x 19.2 in
Port Speed	32 Gbps
Weight	17.6 lbs (8 kg)