SpecificationAC Input Power
20 msOutput holdup time
Power Supply Requirements Specifications
The following table provides a sample calculation of power for the Cisco MDS 9132T switch AC input power
supply.
Table 3: Power Dissipation for AC Input Power Supply
Power
at 220
V/50 Hz
(Watts)
Power
at 110
V/60 Hz
(Watts)
Fan
Modules
PSUVoltageTemperatureTraffic
Rate
LEMSpeedOpticsPower
Mode
747621NormalRoom0%NoNA0Idle
11611821NormalRoom0%YesNA0Idle
9810021NormalRoom50%No32G16Typical
14715021NormalRoom50%Yes32G24Typical
15615921NormalRoom50%Yes32G32Typical
22623142+5%50°C100%Yes32G32Max in
55°C
SFP Transceiver Specifications
The Cisco MDS 9132T switch is compatible with SFP transceivers and cables that have LC connectors. Each
transceiver must match the transceiver on the other end of the cable in terms of wavelength, and the cable
must not exceed the stipulated cable length for reliable communications.
Cisco SFP transceivers support 850 to 1610 nm nominal wavelengths, depending upon the transceiver.
Use only Cisco SFP transceivers on the Cisco MDS 9132T switch. Each Cisco SFP transceiver is encoded
with model information that enables the switch to verify that the SFP transceiver meets the requirements for
the switch. For the list of supported SFP transceivers, see the Cisco MDS 9000 Series Compatibility Matrix.
For details about SFP transceivers see the Cisco MDS 9000 Family Pluggable Transceivers Data Sheet.
For information about safety, regulatory, and standards compliance, see the Regulatory Compliance and Safety
Information for the Cisco MDS 9000 Family.
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
55
Technical Specifications
Power Supply Requirements Specifications
To Next Page
Loading...
Need help?
General
