Cisco MDS 9700 Series

QuantityDescriptionIllustrationPart Number
1 kitGround lug kit (includes the following
parts)
69-1815-XX
1 per kitTwo-hole lug
2 per kitM4 x 8-mm Phillips pan-head screws
1 per kitESD wrist strap
79-0087-XX
1 per kitSFP Extractor700-29059-01
1 per kitProduct Documentation Pointer CardNot applicable78-21186-XX
1 per kitChina Management Methods Hazardous
Substances Content Table
Not applicable78-17985-XX
If you do not receive any part listed in this document, contact Cisco Technical Support at this URL:
http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml. If you purchased this product through a
Cisco reseller, you may receive additional contents in your kit, such as documentation, hardware, and power
cables.
Note
Each new switch ships with country-specific power cords—the shipped cords depend on your specification
when placing a Cisco MDS switch order. The available power cords for the Cisco MDS 9710 Director are as
follows:
• CAB-9K16A-AUS—power cord, 250-VAC 16-A, Src Plug A, Australia
• CAB-9K16A-CH—power cord 250-VAC 16-A, Src Plug GB16C, China
• CAB-9K16A-EU—power cord 250-VAC 16-A, Src Plug CEE, Europe
• CAB-9K16A-INT—power cord 250-VAC 16-A, Src Pl, International
• CAB-9K16A-ISR—power cord 250-VAC 16-A, Src Plug SI16, Israel
• CAB-9K16A-SA—power cord 250-VAC 16-A, Src Plug EL, South Africa
• CAB-9K16A-SW—power cord 250-VAC 16-A, Src Plug SEV 5, Switzerland
• CAB-9K16A-US1—power cord 250-VAC 16-A, Src Plug NE, US and Japan
• CAB-9K16A-US2—power cord 250-VAC 16-A, Src Plug NE, US and Japan
Cisco MDS 9700 Series Switches Hardware Installation Guide
208
Accessory Kit Contents
Accessory Kit Contents