DETAILED STEPS
Step 1 router rib
Example:
RP/0/RP0/CPU0:router# route rib
Enters RIB configuration mode.
Step 2 address-family { ipv4 | ipv6 } next-hop dampening disable
Example:
RP/0/RP0/CPU0:router(config-rib)# address family ipv4 next-hop dampening disable
Disables next-hop dampening for IPv4 address families.
Step 3 commit
Output of show route next-hop Command: Example
The following is sample output from the show route resolving-next-hop command:
show route resolving-next-hop 10.0.0.1
Nexthop matches 0.0.0.0/0
Known via "static", distance 200, metric 0, candidate default path
Installed Aug 18 00:59:04.448
Directly connected nexthops
172.29.52.1, via MgmtEth0/
/CPU0/0
Route metric is 0
172.29.52.1, via MgmtEth0/RP1/CPU0/0
Route metric is 0
Enable RCC and LCC On-demand Scan
Perform this task to trigger route consistency checker (RCC) and Label Consistency Checker (LCC) on-demand
scan. The on-demand scan can be run on a particular address family (AFI), sub address family (SAFI), table
and prefix, vrf, or all prefixes in the table.
SUMMARY STEPS
1. Use one of these commands.
• show rcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name]
• show lcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name]
2. Use one of these commands.
Routing Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.3.x
119
Implementing and Monitoring RIB
Enable RCC and LCC On-demand Scan
To Next Page
Loading...
