Cisco NCS 5500 Series

clear rcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name] log•
• clear lcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name] log
DETAILED STEPS
Step 1 Use one of these commands.
• show rcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name]
• show lcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name]
Example:
RP/0/RP0/CPU0:router#show rcc ipv6 unicast 2001:DB8::/32 vrf vrf_1
Or
RP/0/RP0/CPU0:router#show lcc ipv6 unicast 2001:DB8::/32 vrf vrf_1
Runs on-demand Route Consistency Checker (RCC) or Label Consistency Checker (LCC).
Step 2 Use one of these commands.
• clear rcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name] log
• clear lcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name] log
Example:
RP/0/RP0/CPU0:router#clear rcc ipv6 unicast log
Or
RP/0/RP0/CPU0:router#show lcc ipv6 unicast log
Clears the log of previous scans.
Enable RCC and LCC Background Scan
Perform this task to run a background scan for Route Consistency Checker (RCC) and Label Consistency
Checker (LCC).
SUMMARY STEPS
1. configure
2. Use one of these commands:
• rcc {ipv4 | ipv6} unicast {enable | period milliseconds}
• lcc {ipv4 | ipv6} unicast {enable | period milliseconds}
3. commit
4. Use one of these commands.
Routing Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.3.x
120
Implementing and Monitoring RIB
Enable RCC and LCC Background Scan