Cisco NCS 5500 Series

if destination in (10
.105.3.0/24, 10
.105.7.0/24, 10
.105.13.0/24) then
drop
endif
if destination in (10
.105.3.0/24, 10
.105.7.0/24, 10
.105.13.0/24) then
pass
endif
end-policy
router ospf 1
area 1
route-policy OSPF-area-out out
OSPF Attributes and Operators
This table summarizes the OSPF attributes and operators per attach points.
Table 6: OSPF Attributes and Operators
SetMatchAttributeAttach Point
set—ospf-metricdefault-information
originate
set—metric-type
set—tag
—inrib-has-route
—
indestinationredistribute
set—metric-type
set—ospf-metric
—innext-hop
—route-has-labelmpls-label
n/ais, le, ge, eqrib-metric
—isroute-type
setis, eq, ge, letag
—
indestinationarea-in
—indestinationarea-out
Routing Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.3.x
179
Implementing Routing Policy
OSPF Attributes and Operators