Cisco NCS 5500 Series

If there are parse errors, you are asked whether editing should continue:
RP/0/RP0/CPU0:router#edit route-policy policy_B
== MicroEMACS 3.8b () == rpl_edit.141738
route-policy policy_B
set metric-type type_1
if destination in (2001::/8) then
drop
endif
end-policy
!
== MicroEMACS 3.8b () == rpl_edit.141738 ==
Parsing.
105 bytes parsed in 1 sec (103)bytes/sec
% Syntax/Authorization errors in one or more commands.!! CONFIGURATION
FAILED DUE TO SYNTAX/AUTHORIZATION ERRORS
set metric-type type_1
if destination in (2001::/8) then
drop
endif
end-policy
!
Continue editing? [no]:
If you answer yes, the editor continues on the text buffer from where you left off. If you answer no, the running
configuration is not changed and the editing session is ended.
Editing Routing Policy Configuration Elements Using Vim Editor
Editing elements of a routing policy with Vim (Vi IMproved) is similar to editing them with Emacs except
for some feature differences such as the keystrokes to save and quit. To write to a current file and exit, use
the :wq or :x or ZZ keystrokes. To quit and confirm, use the :q keystrokes. To quit and discard changes, use
the :q! keystrokes.
You can reference detailed online documentation for Vim at this URL: http://www.vim.org/
Editing Routing Policy Configuration Elements Using CLI
The CLI allows you to enter and delete route policy statements. You can complete a policy configuration
block by entering applicable commands such as end-policy or end-set. Alternatively, the CLI interpreter
allows you to use the exit command to complete a policy configuration block. The abort command is used
to discard the current policy configuration and return to mode.
Editing Routing Policy Configuration Elements Using Nano Editor
To edit the contents of a routing policy using the Nano editor, use the following CLI command in XR EXEC
mode:
edit route-policy
name
nano
Routing Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.3.x
185
Implementing Routing Policy
Editing Routing Policy Configuration Elements Using Vim Editor