Cisco NCS 560-4

Uninstalling the Cisco Microsoft Windows USB Driver 97
Uninstalling the Cisco Microsoft Windows XP and 2000 USB Driver Using the Setup.exe
Program 97
Uninstalling the Cisco Microsoft Windows XP and 2000 USB Driver Using the Add Remove
Programs Utility 97
Uninstalling the Cisco Microsoft Windows Vista USB Driver 98
Connecting to the Auxiliary Port 98
Connecting a Management Ethernet Cable 99
Installing and Removing SFP Modules 100
Connecting a USB Flash Device 100
Removing a USB Flash Device 100
Connecting Timing Cables 101
Connecting Cables to the BITS Interface 101
Connecting Cables to the Input 10Mhz or 1PPS Interface 101
Connecting Cables to the Output 10Mhz or 1PPS Interface 102
Connecting Cables to the ToD Interface 102
Connecting Cables to a GNSS Interface 102
Connecting a Cable to the GNSS Antenna Interface 103
Connecting Ethernet Cables 103
Connecting Cables to SFP Modules 104
Installing and Removing SFP Modules 104
Cisco Router Initial Configuration 105
CHAPTER 4
Pinout and LED Details 107
APPENDIX A
Pinouts 107
BITS Port Pinout 107
GPS Port Pinout 108
Time of Day Pinout 108
Alarm Port Pinout 109
Console/Aux RJ45 RS232 Serial Port Pinout 109
Management Ethernet Port Pinout 110
USB Console Port Pinout 111
USB Flash/MEM Port Pinout 111
Cisco NCS 560-4 Router Hardware Installation Guide
vi
Contents