Cisco Nexus 9508 NX-OS User Manual

Rack vertical mounting rails on the rack.3Push the sides of the lower half of the front side of
the chassis (do not push or lift any of the modules or
module handles).
1
Bottom-support rails4Chassis mounting brackets.2
To adjust the placement of the chassis on the bottom-support rails, you can use the chassis handles, see Callout
1 in the following figure.
Tip
Step 5 If the mechanical lift is raised above the height of the bottom-support rails, gently lower it to the level of the rails or no
more than 1/4 inch (0.6 cm) below the rails.
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
29
Installing a Chassis
Installing a Chassis in a Rack or Cabinet

Cisco Nexus 9508 NX-OS Specifications

General

Brand	Cisco
Model	Nexus 9508 NX-OS
Category	Switch
Language	English