• 100G-LC-C, 10x10G-LC, or CFP-LC
• EDRA1-26, EDRA1-35, EDRA2-26, or EDRA2-35
Use the standard brackets directly to mount the ONS 15454 M6 shelf.
Step 5 Align the screw holes on the left front air deflector with the screw holes on the left side of the chassis.
Step 6 Insert the screws and tighten them to a torque value of 11.5 in-lb (1.3 N-m).
Step 7 Return to your originating procedure (NTP).
DLP-G564 Mounting the Bracket with Air Deflectors (Front-to-Back) on the
ONS 15454 M6 Shelf for ETSI Rack Configuration
This task installs the bracket with air deflectors (front-to-back) on the ONS 15454
M6 shelf for ETSI rack configuration.
The air deflectors can be installed only in the front position of the
chassis.
Note
Purpose
• #2 Phillips Dynamometric screwdriver
• Medium slot-head screwdriver
• Small slot-head screwdriver
Tools/Equipment
NTP-G305 Unpack and Inspect the ONS 15454, ONS 15454 M2, and ONS 15454
M6 Shelves
Prerequisite Procedures
As neededRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Use only the fastening hardware provided with the ONS 15454 M6 to prevent loosening, deterioration, and
electromechanical corrosion of the hardware and joined material.
Caution
Procedure
Step 1 Place the right front air deflector flush against the right side of the chassis (see Diagram 1 of Figure 35:
Mounting the Air Deflectors (Front-to-Back) on the ONS 15454 M6 Shelf for ETSI Rack Configuration, on
page 38).
Step 2 Align the screw holes on the right front air deflector with the screw holes on the right side of the chassis.
Step 3 Insert the screws and tighten them to a torque value of 11.5 in-lb (1.3 N-m).
Step 4 Place the left back air deflector flush against the chassis as shown in Diagram 2 of Figure 35: Mounting the
Air Deflectors (Front-to-Back) on the ONS 15454 M6 Shelf for ETSI Rack Configuration, on page 38.
Installing the ONS 15454 M6 Shelf
37
Installing the ONS 15454 M6 Shelf
DLP-G564 Mounting the Bracket with Air Deflectors (Front-to-Back) on the ONS 15454 M6 Shelf for ETSI Rack Configuration