Figure 106: Mixed Multishelf Configuration without a Catalyst Switch Using ONS 15454 M6 as the Node Controller
Step 4 Return to your originating procedure (NTP).
DLP-G683 Connect the ONS 15454 as the Node Controller in a Mixed Multishelf
Configuration
Use this procedure to connect the ONS 15454 as the node controller and a mix
of ONS 15454 and ONS 15454 M6 as subtending shelves using the Catalyst 3560.
Purpose
• Two Cisco Catalyst 3560 switches must be installed in same rack as the node
controller shelf; refer to the Cisco Catalyst 3560 product documentation for
installation instructions.
• Cross-over (CAT-5) LAN cables
Tools/Equipment
NTP-G15 Install the Common Control Cards.
NTP-G313 Install and Configure the TNC, TNCE, TSC, or TSCE Card
Prerequisite Procedures
Installing the ONS 15454 M6 Shelf
145
Installing the ONS 15454 M6 Shelf
DLP-G683 Connect the ONS 15454 as the Node Controller in a Mixed Multishelf Configuration
To Next Page
Loading...