Cisco ONS 15454 M6 - DLP-G737 Replacing 15454-M6-DC With 15454-M6-DC20 Power Module

Figure 78: Installing a Power Filler Module
Step 4 Return to your originating procedure (NTP).
When the ONS 15454 M6 shelf is powered at –60 VDC (nominal), only the TNC, OPT-AMP-C,
OPT-AMP-17-C, OPT-EDFA-17, and OPT-EDFA-24 cards, and the 15454-M6-ECU-60 can be
installed.
Note
DLP-G737 Replacing 15454-M6-DC With 15454-M6-DC20 Power Module
This procedure replaces the 15454-M6-DC with 15454-M6-DC20 power module.Purpose
#2 Phillips Dynamometric screwdriverTools/Equipment
NTP-G259 Open and Remove the Standard Door of the ONS 15454 M6 Shelf ,
on page 57.
Prerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Installing the ONS 15454 M6 Shelf
93
Installing the ONS 15454 M6 Shelf
DLP-G737 Replacing 15454-M6-DC With 15454-M6-DC20 Power Module