Figure 75: AC Power Modules Installed in the ONS 15454 M6 Shelf
Step 3 Return to your originating procedure (NTP).
DLP-G757 Replacing 15454-M6-AC With 15454-M6-AC2 Power module
This procedure is used to replace the 15454-M6-AC with 15454-M6-AC2 power
module.
Purpose
#2 Phillips Dynamometric screwdriverTools/Equipment
NTP-G259 Open and Remove the Standard Door of the ONS 15454 M6 Shelf ,
on page 57.
Prerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Refer to Power Calculation to ascertain the power consumption of the shelf.
Note
Always use the supplied ESD wristband when working with a powered ONS 15454 M6. For detailed instructions
on how to wear the ESD wristband, see the Electrostatic Discharge and Grounding Guide for Cisco CPT and
Cisco ONS Platforms.
Caution
Installing the ONS 15454 M6 Shelf
88
Installing the ONS 15454 M6 Shelf
DLP-G757 Replacing 15454-M6-AC With 15454-M6-AC2 Power module
To Next Page
Loading...