Figure 5: Dimension on Cisco ONS 15454 M6 relative to the air plenum
Air Plenum Rack and Cabinet Compatibility
The table shows the compatibility of air plenum with the ANSI and ETSI racks and cabinets. The chassis can
be installed with brackets in front position only.
Table 1: Air plenum compatibility with racks and cabinets
Front-to-back air flowRack / Cabinet
SupportedANSI 19-inch rack
SupportedANSI 19-inch cabinet
SupportedANSI 23-inch rack
SupportedANSI 23-inch cabinet
SupportedETSI cabinet
A minimum opening of 20.600 inches is required to install the vertical air plenum behind the front rails.
The ANSI 19-inch two post rack that is compatible with air plenum installation is available from Telect, with
part number 12545-301.
Note
Installing the ONS 15454 M6 Shelf
8
Installing the ONS 15454 M6 Shelf
Air Plenum Rack and Cabinet Compatibility
To Next Page
Loading...