Stop. You have completed this procedure.
NTP-G329 Remove the Deep-Front Panel of the ONS 15454 M6
Shelf
This procedure removes the deep-front panel of the ONS 15454 M6 system.Purpose
• #2 Phillips Dynamometric screwdriver
• Socket (6/32 standard) and socket wrench to tighten or loosen the ground
nut
Tools/Equipment
• NTP-G252 Install the ONS 15454 M6 Shelf , on page 24
• NTP-G327 Install the Deep-Front Panel of the ONS 15454 M6 Shelf, on
page 62
• Connect the chassis to the office ground. For detailed instructions on how
to ground the chassis, see the Electrostatic Discharge and Grounding Guide
for Cisco CPT and Cisco ONS Platforms.
Prerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
The deep-front panel does not have a hinge and cannot be rotated like a standard door. Rotating the deep-front
panel can damage the deep-front panel, shelf hinges, other devices and cables placed below the ONS 15454
M6 shelf.
Caution
When the deep front-panel is installed, the total chassis depth is 12.9 inches. The deep front-panel extends
from the rack by 1.8 inches.
Note
Procedure
Step 1 Remove the end of the ground strap cable that is connected to the exterior of the deep-front panel (see the
following figure).
Installing the ONS 15454 M6 Shelf
69
Installing the ONS 15454 M6 Shelf
NTP-G329 Remove the Deep-Front Panel of the ONS 15454 M6 Shelf
To Next Page
Loading...