Cisco ONS 15454 M6

To Next Page

To Previous Page

RequiredRequired/As Needed

OnsiteOnsite/Remote

NoneSecurity Level

If the LCD unit is removed from the shelf, wait for at least 5 seconds before plugging it back into the shelf.

In the event the LCD display appears blank, remove the unit from the shelf, wait for at least 5 seconds and

reinsert the unit into the shelf.

Note

Procedure

Step 1 Insert the LCD module in the central slot (between the power slots) of the chassis (see the following figure).

Figure 79: Installing the LCD Module

Step 2 Push the LCD module into the chassis such that the backplane connector is completely engaged (see the above

figure).

Step 3 Tighten the screw to a torque value of 4 in-lb (0.45 N-m) to lock the unit (see the following figure).

Installing the ONS 15454 M6 Shelf

NTP-G255 Install the LCD Module in the ONS 15454 M6 Shelf

Cisco ONS 15454 M6 - Page 97