Name: Cisco SG350X-24
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

IP Configuration

IPv4 Management and Interfaces

Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 260

• IPv4 Interface

• IPv4 Routes350-550>

•RIPv2

• Access Lists

• VRRP

•ARP

•ARP Proxy

• UDP Relay/IP Helper

• DHCP Snooping/Relay<350-550>

• DHCP Server<350-550>

IPv4 Interface

To manage the device by using the web-based configuration utility, the IPv4 device

management IP address must be defined and known. The device IP address can be manually

configured or automatically received from a DHCP server.

The IPv4 Interface page is used to configure IP addresses for device management. This IP

address can be configured on a port, a LAG, VLAN, loopback interface or out-of-band

interface.

NOTE The device software consumes one VLAN ID (VID) for every IP address configured on a port

or LAG. The device takes the first VID that is not used starting from 4094.

To configure the IPv4 addresses:

STEP 1 Click IP Configuration > IPv4 Management and Interfaces > IPv4 Interface.

To enable IPv4 routing, check the Enable box.

STEP 2 Click Apply. The parameter is saved to the Running Configuration file.

The following fields are displayed in the IPv4 Interface Table:

• Interface—Unit/Interface for which the IP address is defined. This can also be the out-

of-band port.

• IP Address Type—The available options are:

- DHCP—Received from DHCP server.

Questions and Answers:

Need help?

Do you have a question about the Cisco SG350X-24 and is the answer not in the manual?

Cisco SG350X-24 Specifications

General