3
SRP 521 VoIP Gateway Administration Guide 14
REVIEW DRAFT — CISCO CONFIDENTIAL
Setting up the Interfaces of the Gateway
You can use the Inteface Setup pages to setup the WAN, LAN, and Wireless LAN
interfaces.
• Setting up the WAN Interface, page 14
• Setting up the LAN Interface, page 22
• Setting up the Wireless LAN, page 29
• Using the Loopback Interface, page 45
Setting up the WAN Interface
Internet Setup
The settings for WAN networking are set on these pages. In most cases, you can
configure the gateway and get it working properly by using only the settings on
these pages.
NOTE After you configure interfaces settings, you should set a new password for the
gateway using the Adminstration > Access Setting page. This precaution increases
security, protecting the gateway from unauthorized changes. All users who try to
access the web-based Configuration Utility will be prompted for the password of
the gateway.
STEP 1 Click Interface Setup on the tab and then click WAN in the navigation pane. The
Internet Setup page appears.
STEP 2 To add or edit interfaces in the WAN Interface List, click the add or edit icons.
STEP 3 Adjust WAN Phy Settings as necessary.
To Next Page
Loading...
