4
SRP 521 VoIP Gateway Administration Guide 47
REVIEW DRAFT — CISCO CONFIDENTIAL
Configuring the Network
This chapter describes how to configure the network including static routing, NAT,
QoS, the firewall, PPPoE, DDNS, IGMP, UPnP, and CDP.
• Static Routing, page 47
• NAT, page 50
• QoS, page 56
• Firewall, page 59
• PPPoE Relay, page 64
• DDNS, page 65
• IGMP, page 69
• UPnP, page 70
• CDP Setting, page 71
Static Routing
These features are used to set up advanced functions of the gateway. Dynamic
Routing automatically adjusts how packets travel on your network. Static Routing
sets up a fixed route to another network destination.
Static Route Rule
The settings for Static Route Rule are set on this page. It shows the current static
routing list and details of the selected route.
STEP 1 Click Network Setup on the tab and then click Routing in the navigation pane. The
Static Route Rule page appears.
STEP 2 Click Add Rule. The Static Routing Add page opens.
To Next Page
Loading...
