Configuring the Network
QoS
56 SRP 521 VoIP Gateway Administration Guide
4
ALG Control
The ALG Control page lets you enable or disable SIP ALG (Application Layer
Gateway). By default SIP ALG is disabled.
STEP 1 To enable SIP ALG, select Enabled and click Submit.
QoS
Bandwidth Control
Bandwidth control allows the gateway to control the maximum bandwidth for
upstream data transmissions.
STEP 1 Click Network Setup on the tab and then click QoS in the navigation pane. Click
Bandwidth Control. The Bandwidth Control page appears.
STEP 2 Click Enabled to enable bandwidth control. Click Disabled to disable bandwidth
control. Bandwidth control is enabled by default at 50,000 Kbps.
STEP 3 If you enabled bandwidth control, enter the upstream bandwidth value in Kbps.
STEP 4 Click Submit to save your settings.
To Next Page
Loading...
