ID Title Description Solution Severity
20018 Invalid clustering
configuration
H.323 mode must be turned On -
clustering uses H.323
communications between peers
Configure H.323 mode Warning
20019 Cluster name
not configured
If FindMe or clustering are in use a
cluster name must be defined.
Configure the cluster name Warning
25001 Restart required Network configuration has been
changed, however a restart is
required for this to take effect
Restart the system Warning
25002 Date and time
not validated
The system is unable to obtain the
correct time and date from an NTP
server
Check the time configuration Warning
25003 IP configuration
mismatch
IP protocol is set to both IPv4 and
IPv6, but the system does not have
any IPv4 addresses defined
Configure IP settings Warning
25004 IP configuration
mismatch
IP protocol is set to both IPv4 and
IPv6, but the system does not have
an IPv4 gateway defined
Configure IP settings Warning
25006 Restart required Advanced Networking option key
has been changed, however a
restart is required for this to take
effect
Configure your required LAN and
static NAT settings on the IP page
and then restart the system.
Warning
25007 Restart required QoS settings have been changed,
however a restart is required for this
to take effect
Restart the system Warning
25008 Restart required Port configuration has been
changed, however a restart is
required for this to take effect
Restart the system Warning
25009 Restart required Ethernet configuration has been
changed, however a restart is
required for this to take effect
Restart the system Warning
25010 Restart required IP configuration has been changed,
however a restart is required for this
to take effect
Restart the system Warning
25011 Restart required HTTPS service has been changed,
however a restart is required for this
to take effect
Restart the system Warning
25013 IP configuration
mismatch
IP protocol is set to both IPv4 and
IPv6, but the system does not have
an IPv6 gateway defined
Configure IP settings Warning
25014 Configuration
warning
IP protocol is set to both IPv4 and
IPv6, but the VCS does not have
any IPv6 addresses defined
Configure IP settings Warning
25015 Restart required SSH service has been changed,
however a restart is required for this
to take effect
Restart the system Warning
Cisco VCS Administrator Guide (X8.1.1) Page 408 of 507
Reference material
Alarms
To Next Page
Loading...
