ID Title Description Solution Severity
25016 Ethernet speed
not
recommended
An Ethernet interface speed setting
has been negotiated to a value
other than 1000Mb/s full duplex or
100Mb/s full duplex; this may result
in packet loss over your network
Configure Ethernet parameters Warning
25017 Restart required HTTP service has been changed,
however a restart is required for this
to take effect
Restart the system Warning
25018 Port conflict There is a port conflict between
Review the port configuration on the
Local inbound ports and Local
outbound ports pages
Warning
25019 Verbose log
levels
configured
One or more modules of the
Network Log or Support Log are set
to a level of Debug or Trace
Network Log and Support Log
modules should be set to a level of
Info, unless advised otherwise by
your Cisco support representative. If
diagnostic logging is in progress they
will be reset automatically when
diagnostic logging is stopped
Warning
25020 NTP client
failure
The system is unable to run the NTP
client
Check NTP status information,
including any key configuration and
expiry dates
Warning
25021 NTP server not
available
The system is unable to contact an
NTP server
Check Time configuration and status;
check DNS configuration
Warning
25022 Time not
synchronized
over traversal
zone
The system time of this server is
different from that on a server on the
other side of a SIP traversal zone
Ensure that your systems have
consistent Time configuration; note
that any changes may take some
time to become effective
Warning
30001 Capacity
warning
The number of concurrent traversal
calls has approached the licensed
limit
Contact your Cisco representative Warning
30002 Capacity
warning
The number of concurrent traversal
calls has approached the unit's
physical limit
Contact your Cisco representative Warning
30003 Capacity
warning
The number of concurrent non-
traversal calls has approached the
unit's physical limit
Contact your Cisco representative Warning
30004 Capacity
warning
The number of concurrent non-
traversal calls has approached the
licensed limit
Contact your Cisco representative Warning
30005 Capacity
warning
TURN relays usage has
approached the unit's physical limit
Contact your Cisco representative Warning
30006 Restart required The release key has been changed,
however a restart is required for this
to take effect
Restart the system Warning
30007 Capacity
warning
TURN relays usage has
approached the licensed limit
Contact your Cisco representative Warning
Cisco VCS Administrator Guide (X8.1.1) Page 409 of 507
Reference material
Alarms
To Next Page
Loading...
