RemoteSyslogAdd
Adds the address of a remote syslog server.
Address(r): <Value>
The IP address or FQDN of the remote syslog server.
Crlcheck: <On/Off>
Controls whether the certificate supplied by the syslog server is checked against the certificate revocation list (CRL). Default : Off
Format: <bsd/ietf>
The format in which remote syslog messages are written. Default : bsd
Mode: <bsd/ietf/ietf_secure/user_defined>
The syslog protocol to use when sending messages to the syslog server. Default: bsd.
Port: <1..65535>
The UDP/TCP destination port to use. Suggested ports: UDP=514 TCP/TLS=6514 Default : 514
Transport: <udp/tcp/tls>
The transport protocol to use when communicating with the syslog server. Default: udp
Example: xCommand RemoteSyslogAdd Address: "remote_server.example.com" Crlcheck: Off Format: bsd Mode:
bsd Port: 514 Transport: udp
RemoteSyslogDelete
Address(r): <Value>
The IP address or Fully Qualified Domain Name (FQDN) of the remote syslog server to delete.
Port(r): <1..65535>
The port used by the remote syslog server to be deleted.
Transport(r): <udp/tcp/tls>
The transport protocol used by the remote syslog server to be deleted.
Example: xCommand RemoteSyslogDelete Address: "remote_server.example.com" Port: 514 Transport: udp
RemoveRegistration
Removes a registration from the VCS.
Registration: <1..3750>
The index of the registration to be removed.
RegistrationSerialNumber: <S: 1, 255>
The serial number of the registration to be removed.
Example: xCommand RemoveRegistration RegistrationSerialNumber: "a761c4bc-25c9-11b2-a37f-0010f30f521c"
Restart
Restarts the VCS without a full system reboot.
This command has no parameters.
Example: xCommand Restart
Cisco VCS Administrator Guide (X8.1.1) Page 481 of 507
Reference material
Command reference — xCommand
To Next Page
Loading...
