Cisco UCS C240 M5 Service Manual

If VT-d Support and VT Support are already enabled, skip to step 4.
•
•
If VT-d Support and VT Support are not enabled, continue with the next steps to enable them.
e) Press Escape to return to the BIOS Setup utility Advanced tab.
f) On the Advanced tab, choose Processor Configuration to open the Processor Configuration window.
g) Set Intel (R) VT and Intel (R) VT-d to Enabled.
Step 4
Enable the Intel Trusted Execution Technology (TXT) feature:
a) Return to the Intel TXT(LT-SX) Hardware Support window if you are not already there.
b) Set TXT Support to Enabled.
Step 5
Press F10 to save your changes and exit the BIOS Setup utility.
Service Headers and Jumpers
This server includes two blocks of headers (J38, J39) that you can jumper for certain service and debug
functions.
This section contains the following topics:
•
Using the Clear CMOS Header (J38, Pins 9 - 10), on page 113
•
Using the BIOS Recovery Header (J38, Pins 11 - 12), on page 114
•
Using the Clear Password Header (J38, Pins 13 - 14), on page 116
•
Using the Boot Alternate Cisco IMC Image Header (J39, Pins 1 - 2), on page 117
•
Using the Reset Cisco IMC Password to Default Header (J39, Pins 3 - 4), on page 118
Cisco UCS C240 M5 Server Installation and Service Guide
112
Maintaining the Server
Service Headers and Jumpers

Cisco UCS C240 M5 Specifications

General

Form Factor	2U Rack
Storage Controllers	Cisco 12G SAS Modular RAID Controller
Management	Cisco Integrated Management Controller (CIMC)
Processor	Intel Xeon Scalable Processors
Memory	Up to 3TB DDR4
Drive Bays	Up to 12 x 3.5-inch drives