b) Slide the server out the front of the rack far enough so that you can remove the top cover. You might have to detach
cables from the rear panel to provide clearance.
If you cannot safely view and access the component, remove the server from the
rack.
Caution
c) Remove the top cover from the server as described in Removing the Server Top Cover, on page 41.
d) Use two hands to flip up and grasp the blue riser handle and the blue fingergrip area on the front edge of the riser,
and then lift straight up.
e) On the bottom of the riser, push the release latch that holds the securing plate, and then swing the hinged securing
plate open.
f) Open the hinged card-tab retainer that secures the rear-panel tab of the card.
g) Pull evenly on both ends of the HHHL form-factor NVME SSD to remove it from the socket on the PCIe riser.
If the riser has no SSD, remove the blanking panel from the rear opening of the riser.
Step 2
Install a new HHHL form-factor NVME SSD:
a) Open the hinged, plastic card-tab retainer.
b) Align the new SSD with the empty socket on the PCIe riser.
c) Push down evenly on both ends of the card until it is fully seated in the socket.
d)
Ensure that the SSD’s rear panel tab sits flat against the riser rear-panel opening and then close the hinged card-tab
retainer over the rear-panel tab.
e) Close the hinged securing plate.
f) Position the PCIe riser over its socket on the motherboard and over the chassis alignment channels.
g) Carefully push down on both ends of the PCIe riser to fully engage its connector with the sockets on the motherboard.
h) Replace the top cover to the server.
Cisco UCS C240 M5 Server Installation and Service Guide
67
Maintaining the Server
Replacing HHHL Form-Factor NVMe Solid State Drives
To Next Page
Loading...
Need help?
General
