3-52
Cisco UCS C460 Server Installation and Service Guide
OL-22326-01
Chapter 3 Maintaining the Server
Installing or Replacing Server Components
Note You must be logged in as the BIOS administrator to perform this procedure. If you have not done
so already, set a BIOS administrator password on the Security tab of the BIOS Setup utility.
e. Select the Advanced tab.
f. On the Advanced tab, select Trusted Computing to open the TPM Security Device Configuration
screen.
g. Verify that TPM SUPPORT is Enabled. If it is not, set TPM SUPPORT to Enabled.
h. Press Escape to return to the BIOS Setup utility Advanced tab.
Step 2 Enable the Intel Trusted Execution Technology (TXT) feature:
a. On the Advanced tab, select Intel TXT(LT-SX) Configuration to open the Intel TXT(LT-SX)
Hardware Support screen.
Note The Intel Trusted Execution Technology feature can be enabled only when the server has a TPM
installed on the TPM header.
b. Set TXT Support to Enabled.
Step 3 On the same screen, verify that the Intel Virtualization Technology (VT) and the Intel VT for Directed
I/O (VT-d) features are enabled (the factory default).
a. On the Intel TXT(LT-SX) Hardware Support screen, verify that VT-d Support and VT Support are
both listed as Enabled.
–
If they are already enabled, skip to Step 4.
–
If VT-d Support and VT Support are not enabled, continue with the next steps to enable them.
b. Press Escape to return to the BIOS Setup utility Advanced tab.
c. On the Advanced tab, select Processor Configuration to open the Processor Configuration screen.
d. Set Intel (R) VT and Intel (R) VT-d to Enabled.
Step 4 Press F10 to save your changes and exit the BIOS Setup utility.
Step 5 Verify that the Intel TXT, VT, and VT-d features are enabled:
a. Reboot the server.
b. Watch during bootup for the F2 prompt, and then press F2 to enter BIOS setup.
c. Select the Advanced tab.
d. Select Intel TXT(LT-SX) Configuration and verify that TXT Support, VT-d Support, and VT
Support are Enabled.
To Next Page
Loading...
Need help?
General