Send document comments to ucs-docfeedback@cisco.com
Contents
v
Cisco UCS 6100 Series Fabric Interconnect Hardware Installation Guide
OL-20036-02
Installing a Transceiver 3-4
Removing a Transceiver 3-4
Installing or Removing Cables into SFP or SFP+ Transceivers 3-5
Installing a Cable into a Transceiver 3-5
Removing a Cable from a Transceiver 3-6
Maintaining Transceivers and Cables 3-6
Connecting to a Fibre Channel Port 3-7
Installing or Removing SFP Transceivers 3-7
Installing an SFP Transceiver 3-7
Removing an SFP Transceiver 3-8
Installing or Removing Cables into SFP Transceivers 3-9
Installing a Cable into an SFP Transceiver 3-9
Removing a Cable from an SFP Transceiver 3-9
Maintaining SFP Transceivers and Fiber-Optic Cables 3-10
APPENDIX
A System Specifications A-1
Power Specifications A-2
Transceiver Specifications A-3
Environmental Conditions and Power Requirement Specifications for SFP+ Transceivers A-3
General Specifications for Cisco Fibre Channel SFP Transceivers A-3
Environmental Conditions and Power Requirements Specification for SFP Transceivers A-4
APPENDIX
B Accessory Kit for the Cisco UCS Fabric Interconnect B-1
Console Cable B-2
Console Port B-2
Supported Power Cords and Plugs B-3
AC Power Cord Illustrations B-4
Jumper Power Cord B-8
APPENDIX
C Site Preparation Checklist C-1
Contact and Site Information C-3
Chassis and Module Information C-4
APPENDIX
D Overview D-1
SNMP Traps D-1
System Hardware Best Practices D-2
Installation Best Practices D-2
Initialization Best Practices D-2
To Next Page
Loading...
