2-24
Cisco IOS XR Getting Started Guide for the Cisco XR 12000 Series Router
OL-24755-01
Chapter 2 Bringing Up the Cisco IOS XR Software on a Standalone Router
Verifying the System After Initial Boot
show redundancy Command: Example
The following example shows how to display information about the active and standby (inactive) RPs by
entering the show redundancy command:
RP/0/0/CPU0:router# show redundancy
Mon May 31 02:22:27.482 DST
Redundancy information for node 0/0/CPU0:
==========================================
Node 0/0/CPU0 is in ACTIVE role
Node 0/0/CPU0 has no valid partner
Reload and boot info
----------------------
PRP reloaded Mon May 10 16:47:10 2010: 2 weeks, 6 days, 9 hours, 35 minutes ago
Active node booted Mon May 10 16:47:10 2010: 2 weeks, 6 days, 9 hours, 35 minutes ago
Active node reload "Cause: Turboboot completed successfully"
To Next Page
Loading...
